Microscan HE40T User Manual download pdf (Page 24)

Chapter 1 Getting Started

1-14 HawkEye™ 40T User Manual Rev 2.0.0, Jan 2009

FIGURE 1–14. Connecting the USB Cable

2. You DO NOT need to power off your host computer (Figure 1–14). The

HE40T with USB interface can be plugged into any host while the computer

is powered up.

3. Connect the USB interface cable to the host (Figure 1–14). If you are unsure

of the proper location to connect the USB cable, please consult the manual of

your host computer.

4. The USB interface does not require an additional power supply. If you are

using a battery handle (BH1 or BH2) for batch mode, the HE40T will

automatically recharge the battery whenever the reader is a attached to a host

that is powered up.

5. The HE40T will power on automatically.

6. Scan the USB Keyboard Mode code and then the Save Settings code to

configure the reader:

FIGURE 1–15. USB Keyboard Mode & Save Setting Codes

7. Your HE40T reader should be ready for use. Open the application on your

host computer that you wish to send data to and begin scanning.

USB Communication Settings

• USB Keyboard Mode — Data is sent from the Reader and interpreted by the

host just as if a US keyboard was being used to enter data.

Save Settings

USB Keyboard Mode

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 93 94

No comments

Microscan HE40T User Manual Page 24