Microscan MS-4X User Manual download pdf (Page 185)

MS-4X Imager User Manual

7-19

I/O Parameters

Target System

Turns on the target pattern whenever the associated button position is selected. To disable,

quickly press and release the EZ button.

Note: This mode is the only one that does not require that the button be released before

taking effect. Thus, as soon as the imager beeps the appropriate number of times for the

position, it will take effect. If it is necessary to have the target system on before another

operation such as calibration or read rate is performed, ensure that the target system

mode is assigned a lower position so that it will be activated first.

Bar Code Configuration

Enables bar code configuration mode whenever the associated button position is

selected. When enabled, the imager can accept configuration commands from symbols.

To disable, quickly press and release the EZ button.

EZ Button Operation

To execute EZ button commands:

Single Beep (Position #1)

Hold down button until a single beep is heard (and the 20% LED illuminates).

Two Beeps (Position #2)

Hold down button until two quick beeps are heard (and the 20% and 40% LEDs illuminate.)

Three Beeps (Position #3)

Hold down button until three quick beeps are heard (and the 20%, 40%, and 60% LEDs

illuminate).

Four Beeps (Position #4)

Hold down button until four quick beeps are heard (and the 20%, 40%, 60%, and 80%

LEDs illuminate).

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 373 374

Vikitpm 04 Jan 2024 | 15:20:38

urenrjrjkvnm

Evapsi 07 Jan 2024 | 00:41:38

Med

Microscan MS-4X User Manual Page 185