Microscan MS-4 User Manual download pdf (Page 298)

13-2 MS-4 Imager User’s Manual

Serial Utility Commands

Serial Utility Commands

Type Command Name

<C> Enter Decode Rate Test

Read Rate <Cp> Enter Percent Rate Test

<J> Exit Decode Rate and Percent Rate Test

<N> No Read Counter

<O> No Read Counter Reset

<T> Trigger Counter

Counter Request <U> Trigger Counter Reset

and Clear <V> Good Read/Match Counter

<W> Good Read/Match Counter Reset

<X> Mismatch Counter

<Y> Mismatch Counter Reset

<G> Store Next Symbol Read to Database Index 1

Master Database

<Gn> Store Next Symbol Read to Database Index n

<NEWM> New Master Load Status

<#> Display All Firmware Part Numbers

<#a> Display Application Code Part Number

Part Number / <#b> Display Boot Code Part Number

Checksum <#p> Display Profile Module Part Numbers

<!>

Display All Available Firmware Checksums

<!a> Display Application Code Code Checksum

<!b> Display Boot Code Checksum

<!p> Display Profile Module Checksum

<L1> Programmable Output 1

<L2> Programmable Output 2

<L3> Programmable Output 3

Device Control <11> Targeting System On

<10> Targeting System Off

<I> Disable Imager

<H> Enable Imager

<a1> Include PDF Information in Preamble (PDF417)

<A> Reset (does not save for power-on)

<Ard> Reset and Recall Microscan Defaults

<Arp> Reset and Recall Power-On Parameters

Default/Reset/Save <Arc>

Reset and Recall Customer Default Parameters

<Z> Save Current Settings for Power-On

<Zc>

Save Current Settings as Customer Default

Parameters for Power-On

1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 389 390

Comments to this Manuals

No comments