Microscan MS-4X User Manual download pdf (Page 347)

MS-4X Imager User Manual

A-13

Appendices

Serial Command Format

Serial commands are of two types: utility and configuration.

Rules that apply to both utility and configuration commands

• A less than < and greater than > character enclose the commands.

• Commands and data are “case sensitive.” That is, characters must be entered as upper

or lower case, as specified.

Serial Utility Commands

These are sent during operations and are not followed by <A> or <Z>.

Serial Configuration “K” Commands

These begin with a single “K” character followed by a 3-digit numeric character, data

fields, and an initializing command, as follows:

An initializing command <A> or <Z> may follow the command. A <Z> initializes the

imager’s memory and saves for power-on; an <A> initializes the imager’s memory but

does not save for power-on.

For example, to enable UPC and save the change for power-on, send <K473,1><Z>.

To change Baud Rate and reset without saving changes for power-on, send

<K100,3><A>.

Serial Configuration Command Conventions

• All data fields (except the last) must be followed by a comma (without a space).

• NUL cannot be used. The characters <, >, and

, can be used, but only if entered as hex

airs (see ASCII Character Entry Modifier

•

All fields preceding a modified field must be included.

• If there is no change in preceding fields, then commas alone can be entered in these

fields. For example, if only the last field in the following command is changing,

<K100,4,1,0,0> can be entered as <K100,,,,0>.

• All fields following a modified field can be omitted. For example, to change Baud Rate

ly, send <K100,3>.

1 2 ... 342 343 344 345 346 347 348 349 350 351 352 ... 373 374

Vikitpm 04 Jan 2024 | 15:20:38

urenrjrjkvnm

Evapsi 07 Jan 2024 | 00:41:38

Med

Microscan MS-4X User Manual Page 347